BALDOR NEXTMOVE PCI DRIVER

The inputs are conditioned using low pass RC filters and Schmitt trigger buffers. Two module types are available: Four bit resolution analog outputs. Baldor Electric Company P. The NextMove PCI must be installed in an enclosed cabinet located so that it can only be accessed by service personnel using tools. Saving Setup Information 5.

Uploader: Mazuzshura
Date Added: 14 April 2004
File Size: 39.2 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 9518
Price: Free* [*Free Regsitration Required]

Troubleshooting If you bapdor followed all the instructions in this manual in sequence, you should have few problems installing the NextMove PCI. Other Information Needed For Installation ;ci manual is copyrighted and all rights are reserved.

The use of shielded cable is recommended. As a guide, Figure 9 shows an example of the typical minimum wiring required to allow the NextMove PCI and a single axis servo amplifier motor drive to work together.

The use of shielded cable for inputs is recommended.

Read Also:  UML295 DRIVERS

Baldor NEXTMOVE Pci-2 Motion Controller Card 8 Axis Control Opto Isolated I/o | eBay

Servo Axis – Eliminating Steady-state Errors 0. Click Yes to search for firmware.

Only qualified personnel should attempt to start-up, program or troubleshoot this equipment. Selecting A Scale 4. Setting The Drive Enable Output 5. Click Apply at the bottom of the screen. Configuring An Axis If the NextMove PCI nestmove to be stored for several weeks before use, be sure that it is stored in a location that conforms to the storage humidity and temperature specifications shown in section 3.

Page 16 Basic Installation MN Number of tasks limited only by available memory Comprehensive move types including: Units And Abbreviations 2.

Don’t have an account? Installing Workbench V5 5.

Inputs can be configured in MintMT for any of the following functions: Selecting A Scale cpi After a few seconds the setup wizard should start automatically. Do you have questions about our products or services?

Read Also:  MICRO INNOVATIONS IC465C DRIVERS

Baldor NEXTMOVE Pci-2 Motion Controller Card 8 Axis Control Opto Isolated I/o

Digital Inputs x3 Shielded twisted pair cable should be used. The software provided includes a number of applications and utilities to allow you to configure, tune and program the NextMove PCI. The inputs are conditioned using low pass RC filters and Schmitt trigger buffers. Digital Outputs – X5 Voltages below 2V are considered as bldor.

Operation The software provided includes a number of applications and utilities to allow you to configure, tune and nextmve the NextMove PCI. Digital Input Configuration Power – X9 Installing The Nextmove Pci Card For more information visit our Value-Added Service page. Units And Abbreviations